- 符合:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...和更多.
If you use it well, it will not leak oil as much as the OEM type rubber ones. if you degrease the BALI and apply the liquid gas well, and if you reuse it, you can use it almost permanently by removing...閱讀更多 - 符合:
- KAWASAKI Z900 (KZ900) 76-79
- KAWASAKI Z750 (air-cooled) 76-79
- KAWASAKI Z1000 (air-cooled) 76-79
In the paper Float Gasket, the Gasoline is just leaking and the Material is here.:I bought the Rubber Packing. The price is high, but the effect is very large.閱讀更多 - 符合:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...和更多.
Oil leak from Tachometer port is a common disease of air cooled Z.If it starts leaking, replace it with this one.The installation is a little hard, so apply more silicon grease and make sure to put it...閱讀更多 - 符合:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...和更多.
This Nut is well thought out. If it is an aggregate tube, it is possible to fasten it even if it is different Nut somehow, but it is impossible if it is a 4-pipe exhaust system, and this Nut becomes n...閱讀更多 - 符合:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...和更多.
Oil leak & Ntilde. from Tachometer extraction part;It took me a long time to remove it, but I was able to remove it safely in the end. It took me a while to remove it, but I was able to remove it with...閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
Very nicely and precisely made tensioner! This part looks like a work of art, especially in comparing to original cam chain tensioner. This tensioner also fits Kawasaki KZ650 and Zephyr750.閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
I bought this one because the sound came out of the No-Mal Tensioner, but Spring's Weak rebound? I removed the carburetor and this time, the sound became worse I tried to install it with Spacer, but t...閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
I bought this one because the Nomar Tensioner came out sounding, but as per Manual I installed it, but the spring rebound is weak? Notch did not extend and the sound became terrible instead This time ...閱讀更多 - 符合:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...和更多.
if you want to install it on the z1r 2, the quantity of 2 plates for Release:The position of 1pc (upper side) interfered with Stud was bad and Screw could not be attached Because it had no choice, I d...閱讀更多 - 符合:
- KAWASAKI Z1 (900SUPER4) 72-76
- KAWASAKI Z2 (750RS/Z750FOUR) 72-76
- KAWASAKI Z900 (KZ900) 72-76
- KAWASAKI Z750 (air-cooled) 72-76
This time, the bolt head was torn off from a pipe wrench or some other tool I replaced it with the PMC one, which has the same texture as the OEM one and has the same quality as the Stainless steel on...閱讀更多 - 符合:
- KAWASAKI Z2 (750RS/Z750FOUR) 72-75
- KAWASAKI Z1 (900SUPER4) 72-75
- KAWASAKI
- KAWASAKI
I ordered this idler because the idler I had been using was broken It arrived immediately after I ordered and I was in a hurry, so thank you for the large change There was no problem to install it and...閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
It was attached to ZEPHYR 750, but it was a rough sound that is the same as OEM even for the stronger Spring. As I was installing Notch, Bolt was shorter than OEM so half of Tap on Engine side licked ...閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
Nice quality, sets the tension for the cam automatically. Comes with an extra spring and bolts plus spacer for extra sensitive tension.閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
The construction is very good.I think that it would be better to increase the corresponding model.I have attached to ZEPHYR, but I use it without problems.閱讀更多 - 符合:
- KAWASAKI Z900 (KZ900) 76-78
- KAWASAKI Z750 (air-cooled) 76-78
- KAWASAKI
- KAWASAKI
- KAWASAKI Z1000 (air-cooled) 76-78
Because it was not in the applicable car model, it was a bit uneasy, but I also attached Z1R?.If it was not Glaringly it was still good. I also want a matte system.閱讀更多 - 符合:
- KAWASAKI Z750 (air-cooled) 77-80
- KAWASAKI Z1000 (air-cooled) 77-80
- KAWASAKI Z900 (KZ900) 77-80
- KAWASAKI Z900 (KZ900) 77-80
- KAWASAKI Z1000 (air-cooled) 77-80
- ...和更多.
Oil Because it is not expensive at every replacement, we are exchanging.It is very helpful to have such Parts in the old car.Oil There is no leak, and I think it's good.閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
? 【What made you decide the purchase?】 Compared with OEM Product, I chose it with high practicality.? 【How was it actually used?】 Regularly no longer worry about Camshaft Chain.? 【Was it difficult to ...閱讀更多 - 符合:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...和更多.
Oil leaked from the Tachometer port, so I replaced it with the PMC Tachometer port.Installation was easy as it can be exchanged with Hexagon Bolt.If Oil leaks it is recommended to replace it.閱讀更多 - 符合:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...和更多.
Although it can be installed in ZEPHYR 750, it was not self-responsibility because it did not test.However, because it is mounted and running, it was answered that it is possible to install it, and it...閱讀更多 - 符合:
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
Because the state of OEMBolt was bad, this PMC Stainless Steel Bolt Set for Z / I purchased KZ Engine Mount and exchanged it. PMC when purchasing : Z / I got lost as HexHead Bolt Set for KZ Engine Mou...閱讀更多
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING