請不要與其他產生高電壓噪音的產品一起使用,如HID套件和外部點火線圈。該產品僅適用於具有正常電氣系統的汽車。
在 "海外銷售的車輛"、"125cc或以下低功率輸出的車輛 "和 "舊車 "上安裝時,請注意。可能無法使用該產品。
應使用隨附的雙面膠直接固定在車身上。
附帶的雙面膠帶不應該用於固定車把支架。
握把加熱器的溫度極高,不應赤手空拳使用。
這同樣適用於手套,它可能會導致冷燒傷。更多信息,請參考使用手冊。
如果是通用型,必須對連接在車身上的節氣管進行改造,或者單獨購買節氣管。
ptc熱敏電阻被電流的熱量中斷,並通過中斷後的電流量和經過的時間變得溫度很高。在這種情況下,設備可能會變形或融化,這可能是非常危險的,所以請盡快將中斷的設備從設備中取出。
配件電源連接套件會產生熱量,所以請避免將其安裝在可能過熱的地方。
附件電源連接套件的主體是防水的,但終端必須防止進水。
附件電源連接套件具有20a的高功率輸出,但並非所有車輛都能使用20a。請注意,根據車輛、電池狀況和其他因素,這可能增加電池的負荷,並可能導致電池耗盡。
當握把加熱器打開時,握把會發出呼呼的聲音,但這種聲音並不罕見。
安裝時間是基於這樣的假設:你是一名合格的機械師,具有摩托車維修方面的一般知識和技能,並且你已經擁有必要的工具。
請注意,我們沒有檢查過除所列車型外的所有車型的適用性。我們沒有檢查過其他型號的產品的適用性。
請注意,我們不能保證我們的產品適用於未列入兼容車輛列表的車輛。
產品的顏色可能因攝影條件、顯示器、產品批次和套裝的左側或右側而有所不同。
其他產品也包括在圖片中。
請注意,由於制造商的原因,產品規格可能會有變化。請理解。
[Material] Accessory power connection kit case body: Aluminum (black alumite)
[Grip length] 115mm
[Grip diameter] Φ34
[Size]
・Accessory Power Supply Connection Kit Unit (Approx.): 22.3 x 37.8 x 36.5
・Accessory power connection kit bullet terminal (approx.): Φ3.5
[Power consumption] 8-40W
[Installation time] Varies depending on the model
[Set components]
・Grip heater HG115 x 1
・Accessory Power Supply Connection Kit x 1
・Sub Harness x 1
*Please do not install the product which emits high voltage noise such as HID kit and a third party ignition coil together.This product is only for vehicles with stock electrical system.
*Please be careful when installing the product on "vehicles sold overseas", "vehicles with a low power output of 125cc or less", and "older vehicles".You may not be able to use it.
*Please use the included double-sided tape for direct attachment to the vehicle.
*Do not use the included double-sided tape to secure the handlebar bracket.
*Please do not use the grip heater with bare hands because it becomes very hot.
*Please be careful even with gloves on, as there is a risk of low temperature burns.For details, please refer to the instruction manual.
*In the case of the universal type, you need to modify the throttle tube attached to the vehicle or purchase a throttle tube separately.
*PTC thermistors are cut off by the heat of the current, and become very hot depending on the amount of current and elapsed time after cut off.In this case, it may deform or melt the main unit, which is very dangerous. Remove the interrupted device from the main unit as soon as possible.
*The main unit of the accessory power connection kit generates heat, so avoid installing it in a place where it is likely to be overheated.
*The main unit of the accessory power supply connection kit is waterproof, but the terminal part must be treated so that it is not exposed to water.
*The accessory power connection kit has a high output of 20A, but not all vehicles can use 20A.Depending on the vehicle, battery condition, or other factors, the load on the battery may increase, which may cause the battery to run out of power.
*As the grip heater is energized, there is a whining sound from the grip, but this sound is not abnormal.
*The installation of models is not checked other than those listed in the compatibility check list.If your vehicle is not listed, it cannot be installed or has not been tested.
*The installation of the product to the models that are not listed in the compatibility check list is not guaranteed.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product.
*Images may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.