- I was using it on a W800, and it was a little expensive, but I installed it because the W800 is air-cooled and there is a lot of room around the engine.Used with normal muffler and air cleaner, the re...閱讀更多
- I use it for my Circuit practice runs.I don't need it to be full, but it is too thin as it is on NORMAL.Exhaust system was replaced and air cleaner OEM was installed, but Torque was raised and the bur...閱讀更多
- When the exhaust pipe was removed, the exhaust valve was too white and we wanted to reduce the engine heat generation.Dial was adjusted at the specified value, and EngineCheckLamp was illuminated when...閱讀更多
- The Z900RS has two O2 Sensor feedback areasAxel opening 5%. (Much thinner than ideal air-fuel consumption) and 20% opening (still a little thin) The only two places where you can find the full Exhaust...閱讀更多
- [How is it used?TouringWas the one you received as per Image?There were no missing parts, etc.How was your experience with it?The sluggishness at low and medium speeds has been improved.However, since...閱讀更多
- Peyton PlaceCABTON Exhaust SystemIt does not correspond to JMCA.(Injection type) installed on a Model 5 SR.I bought this product because the stalling and after fire was terrible.Quantity with Manufact...閱讀更多
- I think even beginners can install it rather easily.However, I do not expect this product to increase power in the entire range, but rather to compensate for the thinning of the mid and low speed rang...閱讀更多
- I bought one with 1 pc. left in stock. Maybe it was an old one?I opened the package and found that there are a lot of white dusts all around the Knob on the Setting side. I don't want the ECU to throw...閱讀更多
- I purchased this product to prevent AfterFire Ya when I installed the Wye BurnFull Exhaust System on my W800.When running at low RPMs, afterfire does not occur even if the throttle is turned back. Als...閱讀更多
- Torque at low to mid speeds seems to have increased with the installation. for Circuit Racing's ZX-6R (2012) Although it is a circuit run, there is also low speed run such as PitRoad, so I think it is...閱讀更多
- Purchased to improve acceleration from low rpm and engine engagement.The type of O2Sensor is to be inserted into the O2Sensor Wiring, but the work was completed without even removing the tank. However...閱讀更多
- The installation is Couplet-on, so there is no problem if you follow the instructions in the manual that comes with it. The basic setting is also included in the manual, which is very helpful. However...閱讀更多
- I installed it on a 2021model DL1000 V-STROM650XT. The sub harness included with the unit was complete-on, and the warning light does not come on when the engine is started, so it seems to be working ...閱讀更多
- When accelerating at full throttle from low rpm, there is a gasp and the Torque comes out suddenly at the beginning of opening, and sometimes the Response is too good, so we have been searching for a ...閱讀更多
- HORNET900Sub computer 2002 MODEL does not have O 2Sensor RabbitMotorcycleEasyKit 30250Product0 2SensorMODEL I don't know what to do.閱讀更多
- [How is it used?i installed it on klx250The vehicle is equipped with FMF Slip-on Silencer, otherwise NORMAL.Was the installation difficult?It is easy to attach with Couplet-on, but I was quite confuse...閱讀更多
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING