智慧型手機支架 iH-220

[Color] Black
[Product Code]
・IH-220-S model: 339-3350-00
・IH-220-M model: 339-3351-00
[Material] Resin, Aluminum
[Weight]
・IH-220-S model: 145g
・IH-220-M model: 146g
[Maximum holdable weight] Up to 300g
[Mountable size (diameter)]
・IH-220-S model: 22.2 (typical bike handlebar size) to 28.6
・IH-220-M model: From 28.6 to 35 (including handlebar size / 31.8 which is common in sports bikes)
[Specification]
・Recommended design size: Smart Phone / Protective Case Width 55mm -85mm, Thickness 6mm -18mm
・One-touch clamp
one year

*[Cautions and Restrictions on Installation of Telephone Equipment]
*There is no waterproof function to protect the phone from rain.Using the phone in the rain may cause the phone to get wet and break.Please take responsibility for waterproofing measures individually.It has been verified that the device can be operated even when it is placed in a sealable plastic bag such as a ziplock.
*Designed with a locking mechanism that securely holds the phone and prevents it from being released accidentally, but it cannot withstand large impacts that may occur when the user forgets to set the lock, drives on rough roads, or goes over bumps in the road.Be very careful and always ride at a slow speed depending on the situation.We are not responsible for any compensation even if the mobile phone comes off the holder body and falls.The use of this product is at the user's own risk.
*Not all phone functions can be used while on the holder because the position of the camera, speaker, and earphone jack are different among the models of each manufacturer.
*The size of the phone will vary depending on the user, such as the phone alone or with a protective case.The side hooks at the tip of the wing can be changed and adjusted by the user. Please be sure to adjust the size of the wing to your own size before using it.
*The clamp from the side of the phone is designed to exert considerable force, but because it is made of resin, it may break if it deteriorates over time due to ultraviolet rays or other factors.Keep an eye on your phone at all times.

[Cautions and restrictions regarding installation of the main unit]
*For the quick clamp, first adjust the clamping force with the adjustment screw at the base of the clamp to obtain the appropriate clamping force, and then turn down the locking lever.The holder can be installed by tightening the screw after the lever is turned down, but the tightening torque is not sufficient and the holder may wobble during use.
*Make sure that the adjustment bolt is fully retracted into the holder body when the lever is clamped.If the bolt is still floating, it is not clamped firmly.
*To prevent scratches and to ensure sufficient clamping force, wrap the supplied transparent sheet around the handlebar and install it over the sheet.
*When raising the lever, operate it with your finger, not with your fingernail only.The lever is closed with a strong force, which may injure your fingernail.
*On drop bars for road use where the brake and shift wires are installed along the handlebar, the clamp may apply excessive force to the cable and crush the outer cable.It is recommended to install the unit as far away from the cables as possible.
*This product cannot be installed on handlebars or seat posts with a non-circular cross-section.
*We are not responsible for the theft of equipment while parked due to the ease of removal.When you park your bike, please remove it and take it with you.
*Operating a mobile phone while driving is prohibited by law and is extremely dangerous.Staring at the screen for a long period of time can also lead to inattention to the road ahead, which can lead to accidents.Use and operation of cell phones must be done at your own risk and in compliance with local laws and regulations..